I Saving Your Preferred Stitch Settings - Brother ULT-2003D Operation Manual

I Saving Your Preferred Stitch Settings

The settings for zigzag stitch width, stitch length, thread tension, automatic thread cutting or auto-
matic reinforcement stitching, etc., are preset by the computer for each stitch pattern. If you want
to change those settings, input the new settings and press
change. The new settings will replace the computer settings.
3-12
Example: You always use a length setting of
2.0 mm (1/16 inch) for a straight stitch
1. Select the straight stitch.
2. Set the length to 2.0 mm (1/16 inch), and press
3. Press , and go back to the original screen, or turn off the
machine. The next time you select the same straight stitch, the
stitch length setting should be 2.0 mm, as you saved it.
CAUTION
• You can change any of the settings on the
• If you do not press
settings, the new stitch settings will be displayed whenever you
select that stitch, even after turning off the power.
* Press to return to the original machine settings.
Then press to memorize these settings.
Sewing Utility Stitches
for each pattern you want to
screen in the same manner.
or after saving the new stitch
1 —
2 —
3 —
.
4 —
5 —
6 —
7 —
8 —
9 —