Connecting Onkyo U Components - Onkyo TX-NR515 Instruction Manual

Connecting Onkyo u Components

1
Make sure that each Onkyo component is connected
with an analog audio cable (connection
hookup examples) (➔ page 17).
2
Make the u connection (see the illustration).
3
If you're using an RI Dock, or cassette tape deck,
change the Input Display (➔ page
With u (Remote Interactive), you can use the following
special functions:
■
System On/Auto Power On
When you start playback on a component connected via
u, while the AV receiver is on standby, the AV
receiver will automatically turn on and select that
component as the input source.
■
Direct Change
When playback is started on a component connected via
u, the AV receiver automatically selects that
component as the input source.
■
Remote Control
You can use the AV receiver's remote controller to
control your other u-capable Onkyo components,
pointing the remote controller at the AV receiver's
remote control sensor instead of the component. You
must enter the appropriate remote control code first
(➔ page 72).
F in the
43).
e.g., cassette tape deck
Note
• Use only u cables for u connections. u cables are supplied
with Onkyo components.
• Some components have two u jacks. You can connect either
one to the AV receiver. The other jack is for connecting
additional u-capable components.
• Connect only Onkyo components to u jacks. Connecting other
manufacturer's components may cause a malfunction.
• Some components may not support all u functions. Refer to the
manuals supplied with your Onkyo components.
• While Zone 2 is on, the System On/Auto Power On and Direct
Change u functions do not work.
R L
ANALOG
AUDIO OUT
R L
ANALOG
AUDIO OUT
RI Dock
En-18
Connections