Connecting Onkyo Components; Connecting The Rs232 Port; Connecting The Power Cord - Onkyo TX-SR705 Instruction Manual

Connecting the AV Receiver/AV Amplifier
Connecting Onkyo
Step 1: Make sure that each Onkyo component is
connected to the AV receiver/AV amplifier
with an analog audio cable (connection
in the hookup examples) (see pages 29 to
40).
Step 2: Make the connection.
Step 3: If you're using an MD, CDR, or RI Dock,
change the input display (see page 50).
With (Remote Interactive), you can use the follow-
ing special functions:
■ Auto Power On/Standby
When you start playback on a component connected
via , if the AV receiver/AV amplifier is on
Standby, it will automatically turn on and select that
component as the input source. Similarly, when the
AV receiver/AV amplifier is set to Standby, all com-
ponents connected via
■ Direct Change
When playback is started on a component connected
via , the AV receiver/AV amplifier automatically
selects that component as the input source. If your
DVD player is connected to the AV receiver/AV
amplifier's multichannel DVD input, you'll need to
press the [MULTI CH] button to hear all channels
(see page 60), as the Direct Change
only selects the DVD FRONT L/R jacks.
■ Remote Control
You can use the AV receiver/AV amplifier's remote
controller to control your other
components, pointing the remote controller at the
AV receiver/AV amplifier's remote control sensor
instead of the component. You must enter the appro-
priate remote control code first (see page 105).
Notes:
• Use only cables for
are supplied with Onkyo players (DVD, CD, etc.).
• Some components have two
nect either one to the AV receiver/AV amplifier. The
other jack is for connecting additional
components.
• Connect only Onkyo components to
necting other manufacturer's components may cause a
malfunction.
• Some components may not support all
Refer to the manuals supplied with your other Onkyo
components.
• While Zone 2 is on, the Auto Power On/Standby and
Direct Change functions do not work.
Components
a
will also go on Standby.
function
-capable Onkyo
connections. cables
jacks. You can con-
-capable
jacks. Con-
functions.
REMOTE
CONTROL
e.g., CD player
e.g., DVD player

Connecting the RS232 Port

This port is for connecting the AV receiver/AV amplifier
to home automation equipment and external controllers.

Connecting the Power Cord

Notes:
• Before connecting the power cord, connect all of
your speakers and AV components.
• Turning on the AV receiver/AV amplifier may cause a
momentary power surge that might interfere with
other electrical equipment on the same circuit. If this
is a problem, plug the AV receiver/AV amplifier into a
different branch circuit.
• Do not use a power cord other than the one supplied
with the AV receiver/AV amplifier. The supplied
power cord is designed exclusively for use with the
AV receiver/AV amplifier and should not be used with
any other equipment.
• Never disconnect the power cord from the AV
receiver/AV amplifier while the other end is still
plugged into a wall outlet. Doing so may cause an
electric shock. Always disconnect the power cord
from the wall outlet first, and then the AV receiver/AV
amplifier.
Step 1 (not North American model):
Connect the supplied power cord to the AV
receiver/AV amplifier's AC INLET.
To AC wall outlet
Step 2: Plug the power cord into an AC wall outlet.
(The Standby indicator lights up.)
IN
L
R
CD
FRONT
L
R
DVD
R L
ANALOG
AUDIO OUT
R L
ANALOG
AUDIO OUT
43