Playback; Playing The Connected Component - Onkyo TX-NR515 Instruction Manual

Playback

The on-screen menus appear only on a TV that is
connected to the HDMI OUT MAIN. If your TV is
connected to other video outputs, use the AV
receiver's display when changing settings.
This section describes the procedure for using the
remote controller, unless otherwise specified.

Playing the Connected Component

■
Operating with the remote controller
INPUT SELECTOR
RECEIVER
VOL q/w
Listening mode buttons
1 Press RECEIVER followed by an INPUT
SELECTOR button.
2 Start playback on the source component.
See also:
• "Playing an iPod/iPhone via USB"
• "Playing a USB Device" (➔ page
• "Listening to vTuner Internet Radio"
• "Registering Other Internet Radio"
• "Playing Music Files on a Server"
• "Remote Playback" (➔ page 30)
• "Listening to AM/FM Radio" (➔ page
• "iPod/iPhone Playback via Onkyo Dock"
(➔ page 68)
• "Controlling Other Components"
3
To adjust the volume, use VOL q/w.
4
Select a listening mode and enjoy!
See also:
• "Using the Listening Modes" (➔ page
En-23
■
Operating on the AV receiver
LISTENING MODE
1
Use the input selector buttons to select the input
source.
2
Start playback on the source component.
3
To adjust the volume, use the MASTER VOLUME
control.
4
Select a listening mode and enjoy!
(➔ page 25)
26) ■
Screen saver
(➔ page 27)
If there is no video signal on the current input source and
(➔ page 28)
no operation for a specific time (three minutes by
(➔ page 29) default), a screen saver automatically comes on.
Tip
31)
• The time until the screen saver activates itself can be changed
in the "Screen Saver" setting
• The screen will return to its previous state if the AV receiver is
(➔ page 70)
operated.
37)
Turning On & Basic Operations
Input selector buttons
MASTER VOLUME
(➔ page 61).