Using The Sleep Timer; Setting The Display Brightness; Displaying Source Information; Changing The Input Display - Onkyo TX-NR515 Instruction Manual

Using the Sleep Timer

With the sleep timer, you can set the AV receiver to turn
off automatically after a specified period.
1
Press RECEIVER once followed by SLEEP
repeatedly to select the required sleep time.
The sleep time can be set from 90 to 10 minutes in 10
minute steps.
The SLEEP indicator lights on the AV receiver's
display when the sleep timer has been set. The
specified sleep time appears for about 5 seconds, then
the previous display reappears.
Tip
• If you need to cancel the sleep timer, press SLEEP
repeatedly until the SLEEP indicator goes off.
• To check the time remaining until the AV receiver sleeps,
press SLEEP. Note that if you press again on SLEEP as
the time being displayed is 10 minutes or less, the sleep
timer will go off.

Setting the Display Brightness

You can adjust the brightness of the AV receiver's display.
1 Press RECEIVER once followed by DIMMER
repeatedly to switch between: normal, dim, or
dimmer brightness.
Tip
• (North American and Taiwanese models) Alternatively,
you can use DIMMER on the AV receiver.

Displaying Source Information

You can display various information about the current
input source as follows.
1
Press RECEIVER once followed by DISPLAY
repeatedly to cycle through the available
information.
Tip
• Alternatively, you can use DISPLAY on the AV receiver.
The following information can be typically displayed.
Input source &
*1
volume
Listening mode
Signal format *2
Sampling
frequency *2
Input signal
resolution
Output resolution
*1 When AM or FM radio is used, the band, preset number, and
frequency are displayed.
*2 If the input signal is digital, the signal format is displayed.
Information is displayed for about three seconds, then the
previously displayed information reappears.
En-43
Turning On & Basic Operations

Changing the Input Display

When you connect an u-capable Onkyo component, you
must configure the input display so that u can work
properly.
This setting can be done only from the front panel.
1 Press TV/CD or GAME.
"TV/CD" or "GAME" appears on the AV receiver's
display.
2
Press and hold down the same button (about
3 seconds) to change the input display.
Repeat this step to select the desired input display.
→
■
TV/CD:
TV/CD DOCK
→
TAPE
■ GAME ↔ DOCK
GAME:
"
Note
• "DOCK" can be selected for the "TV/CD" or "GAME"
input selector, but not at the same time.
• Enter the appropriate remote control code before using the
(➔ page
remote controller for the first time
72).