Connecting And Operating Onkyo Ri Components; Summary Of Ri Function; Ri Connection And Settings - Onkyo TX-NR535 Advanced Manual

Connecting and Operating
Onkyo RI Components

Summary of RI function

Connecting an Onkyo component with RI jack such as the
separately sold RI Dock to the unit by using an RI cable
and an analog audio (RCA) cable enables the following RI
functions:
System On/Auto Power On: Starting playback on a
component connected via RI when the unit is on standby
mode, automatically turns on the unit to select the relevant
component as its input source.
Direct Change: When playback is started on a component
connected via RI, the unit selects that component as the
input source.
Remote Controller Operation: Allows you to operate RI-
compatible Onkyo components using the AV receiver's
remote controller. Point the remote controller at remote
control sensor of the unit. This operation is possible only
when the RI remote control code is programmed.
⿠ Some components may not support all RI functions.
⿠ These functions do not work when Zone 2 is turned on.
⿠ For information on the RI functions, also refer to each
component's instruction manual.
34

RI connection and settings

L
R
Connect an Onkyo component with RI jack to the unit using
an RI cable and an analog audio (RCA) cable. For details,
refer to the instruction manual of the component with RI
jack. The RI cable can be connected in any order. When
there are two RI jacks, you can connect to either one as
both jacks work in the same way.
To connect the RI Dock or cassette tape deck via RI, you
must:
■ Renaming the Input Selector
To make the RI functions work, you must rename the input
selectors. Press RCV on the remote controller to switch its
mode to RECEIVER mode and the press HOME. Select
"9. Source Setup" in "Setup" menu and Rename the input
selector by setting "DOCK" or "TAPE".
■ Program the RI remote control code
Program the remote control code to desired REMOTE
MODE button on the remote controller. This will allow you to
operate the component by pointing the remote controller at
the unit instead of the component.

Connecting and Operating Onkyo RI Components

1.
Press DISPLAY for 3 or more seconds while holding
down the REMOTE MODE button to which you want to
program the remote control code. The remote indicator
lights.
⿠ The RCV, ZONE2, and TV buttons cannot be
programmed.
2.
With the number buttons, enter the following 5-digit
remote control code within 30 seconds.
⿠ RI Dock: 81993
⿠ Cassette tape deck with RI jack: 42157
Programming is complete when the remote indicator
flashes twice. The remote indicator flashes once slowly
when programming the remote control code fails. Try
programming again.
Input selector on the RI Dock: Select "HDD" or "HDD/
DOC". For details, refer to the RI Dock's instruction manual.
To operate Onkyo components directly or Onkyo
components that are not connected via RI, use the
following remote control codes:
Onkyo DVD player: 30627
Onkyo CD player: 71817
RI Dock: 82990
⿠ With some models, operation may not be possible in
part or not possible at all.