Controlling Other Components; Preprogrammed Remote Control Codes; Looking Up For Remote Control Codes - Onkyo TX-NR515 Instruction Manual

Controlling Other
Components
You can use the AV receiver's remote controller to control
your other AV components. This section explains how to
enter the remote control code for a component that you
want to control: DVD, TV, CD, etc.
Preprogrammed Remote Control
Codes
The following REMOTE MODE buttons are
preprogrammed with remote control codes for controlling
the components listed. You do not need to enter a remote
control code to control these components.
For details on controlling these components, see the
indicated pages.
BD/DVD Onkyo Blu-ray Disc player
TV/CD Onkyo CD player (➔ page

Looking up for Remote Control Codes

You can look up for an appropriate remote control code
from the on-screen menu.
Note
• This can only be carried out using the on-screen menu.
1
Press RECEIVER followed by HOME.
2
Use e/r to select "Setup", and then press ENTER.
3
Use q/w to select "Remote Controller Setup", and
then press ENTER.
4
Use q/w to select "Remote Mode Setup", and then
press ENTER.
5
Use q/w to select a remote mode, and then press
ENTER.
The menu of category selection appears.
(➔ page 73)
6
Use q/w to select a category, and then press
72)
ENTER.
The keyboard screen for brand name input appears.
7
Use q/w/e/r to select a character, and then press
ENTER.
Repeat this step for the first three characters of the
brand name.
When you have entered the 3rd character, select
"Search" and press ENTER.
A list of brand names is retrieved.
If the desired brand name is not found:
Use r to select "Not Listed", and then press
ENTER.
The keyboard screen for brand name input appears.
8
Use q/w to select a brand, and then press ENTER.
A remote control code with its instructions are
displayed. Follow the procedure.
En-70

Controlling Other Components

9
If you can control the component, use q/w to select
"OK", and then press ENTER.
The on-screen menu returns to the "Remote Mode
Setup" front screen.
If you cannot control the component, use q/w to
select "Try next code" and press ENTER.
The next code is displayed.