Connecting And Operating Onkyo Ri Components; About Ri Function; Ri Connection And Setting - Onkyo TX-NR646 User Manual

Connecting and Operating
Onkyo RI Components

About RI Function

Connecting an Onkyo component with RI jack such as
the separately sold RI Dock to the unit by using an RI
cable and an analog audio cable enables the following RI
functions:
System On / Auto Power On: Starting playback on a
component connected via RI when the unit is on standby
mode, automatically turns on the unit to select the relevant
component as its input source.
Direct Change: When playback is started on a component
connected via RI, the unit selects that component as the
input source.
Remote Controller Operation: Allows you to operate
RI-compatible Onkyo components using the AV receiver's
remote controller. Point the remote controller at remote
control sensor of the unit. This operation is possible only
when the RI remote control code is programmed.
● Some components may not support all RI functions.
● These functions do not work when Zone 2 is turned on.
● For information on the RI functions, also refer to each
component's instruction manual.
En-52

RI Connection and Setting

Connect an Onkyo component with RI jack to this unit using
an RI cable and an analog audio cable. For details, refer
to the instruction manual of the component with RI jack.
The RI cable can be connected in any order. When there
are two RI jacks, both jacks work in the same way and are
interchangeable.
To connect the RI Dock or cassette tape deck via RI, the
following settings are required.
 Rename the input selector
¼
To make the RI functions work, you must rename the input
selectors on the unit. Press CD or GAME to display "CD"
or "GAME" on the main unit display. Then press and hold
CD or GAME 3 seconds or more to switch the display to
"DOCK" or "TAPE".
 To program the RI remote control code
¼
Program the remote control code to any REMOTE MODE
button on the remote controller. This will allow you to
operate the component by pointing the remote controller at
the unit instead of the component.
1. Press and hold DISPLAY for 3 or more seconds while
holding down the REMOTE MODE button to which you
want to program the remote control code.
● The remote indicator will light.
● The RECEIVER and ZONE2 buttons cannot be
programmed.

Connecting and Operating Onkyo RI Components

2. With the number buttons, enter the following 5-digit
remote control code within 30 seconds.
L
RI Dock: 81993
R
Cassette tape deck with RI jack: 42157
● Programming is complete when the remote indicator
flashes twice. The remote indicator flashes once
slowly when programming the remote control code
fails. Try programming again.
Input selector on the RI Dock: Switch to "DOCK" or
"TAPE"� For details, refer to the RI Dock's instruction
manual.
To operate Onkyo components directly or Onkyo
components that are not connected via RI, use the
following remote control codes:
Onkyo DVD player: 30627
Onkyo CD player: 71817
RI Dock: 82990
● With some models, operation may be not possible in
part or not possible at all.