Audio Adjust Functions - Onkyo SR705 - TX AV Receiver Instruction Manual

TX-SR705_En.book Page 85 Monday, May 28, 2007 2:13 PM
Advanced Setup—Continued

Audio Adjust Functions

Here you can set listening mode-related settings and
functions.
1 Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.
2
Use the Up and Down [
buttons to select "3. Audio
Adjust," and then press [ENTER].
The Audio Adjust menu appears.
ENTER
3. Audio Adjust
1. Tone Control
2. Multiplex/Mono
3. PL II x/Neo:6
4. Dolby EX
5. Theater-Dimensional
6. LFE Level
ENTER
3
Use the Up and Down [ ]/[ ]
buttons to select the functions,
and then press [ENTER].
The function menu you selected
ENTER
appears.
ENTER
4
Use the Up and Down [
buttons to select the settings,
and use the Left and Right [
[ ] buttons to set them.
ENTER
The settings are explained below.
ENTER
5
Note:
This procedure can also be performed on the AV
receiver/AV amplifier by using its [SETUP] button,
arrow buttons, and [ENTER] button.
The Audio Adjust functions are explained below.
Tone Control Settings
]/[ ]
You can adjust the bass and treble for the front speakers,
except when the Direct or Pure Audio listening mode is
selected.
■ Bass
You can boost or cut low-frequency sounds output by the
front speakers from –10 dB to +10 dB in 2 dB steps.
■ Treble
You can boost or cut high-frequency sounds output by
the front speakers from –10 dB to +10 dB in 2 dB steps.
Note:
The tone control settings do not apply to the THX listen-
ing modes.
Multiplex/Mono Settings
■ Multiplex Input Ch
This setting determines which channel is output from a
stereo multiplex source. Use it to select audio channels
or languages with multiplex sources, multilingual TV
broadcasts, and so on.
Main: The main channel is output (default).
Sub: The sub channel is output.
Main/Sub: Both the main and sub channels are output.
■ Mono Input Ch
This setting specifies the channel to be used for playing
]/[ ]
any 2-channel digital source such as Dolby Digital, or 2-
channel analog/PCM source in the Mono listening
]/
mode.
L+R: Both the left and right channels are output
(default).
L: Only the left channel is output.
R: Only the right channel is output.
■ Output Speaker
This setting determines which speakers output mono
audio when the Mono listening mode is selected.
L/R: Mono audio is output by the front left and right
speakers.
C: Mono audio is output by the center speaker
(default).
When you've finished, press the
[SETUP] button.
The setup menu closes.
85