Onkyo SR705 - TX AV Receiver Instruction Manual page 83

TX-SR705_En.book Page 83 Monday, May 28, 2007 2:13 PM
Advanced Setup—Continued
6
Use the Up and Down [
buttons to select a frequency,
and then use the Left and Right
[ ]/[ ] buttons to adjust the
ENTER
level at that frequency.
The volume at each frequency can be
adjusted from –6 to +6 dB in 1 dB
steps.
Tip: Low frequencies (e.g., 160 Hz)
affect bass sounds; high frequencies
ENTER
(e.g., 6300 Hz) affect treble sounds.
7
Use the Up [
"Channel," and then use the Left
and Right [
select another speaker.
ENTER
Repeat step 6 and 7 for each speaker.
ENTER
8
Press the [SETUP] button.
The setup menu closes.
Notes:
• When the listening mode is set to Direct or Pure
Audio, no effect will be produced.
• Depending on the input source or listening mode, the
Equalizer settings may not produce the desired effect.
• This procedure can also be performed on the AV
receiver/AV amplifier by using its [SETUP] button,
arrow buttons, and [ENTER] button.
THX Audio Setup
]/[ ]
With the Surr Back Sp Spacing setting, you can specify
the distance between your surround back speakers.
1
] button to select
]/[ ] buttons to
2
3
These settings are not set automatically by the Auto-
matic Speaker Setup function (see page 54).
Press the [RECEIVER] REMOTE
MODE button, followed by the
[SETUP] button.
The main menu appears onscreen.
Use the Up and Down [ ]/[ ]
buttons to select "2. Speaker
Setup," and then press [ENTER].
The Speaker Setup menu appears.
ENTER
2. Speaker Setup
1. Speaker Settings
2. Speaker Config
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
6. THX Audio Setup
ENTER
Use the Up and Down [ ]/[ ]
buttons to select "6. THX Audio
Setup," and then press [ENTER].
The THX Audio Setup screen appears.
ENTER
2–6. THX Audio Setup
Surr Back Sp Spacing
ENTER
<1ft
83