Speaker Settings - Onkyo SR705 - TX AV Receiver Instruction Manual

TX-SR705_En.book Page 46 Monday, June 4, 2007 2:18 PM
First Time Setup—Continued

Speaker Settings

If you change these settings, you must run the auto-
matic speaker setup again (see page 54).
If the impedance of any speaker is 4 ohms or more but
less than 6, set the minimum speaker impedance to 4
ohms (not North American models).
If you've connected your front speakers to the FRONT
SPEAKERS and SURR BACK SPEAKERS terminal
posts for bi-amping, you must change the Speakers Type
setting. For hookup information, see "Bi-amping the
Front Speakers" on page 24.
Notes:
• When bi-amping is used, the AV receiver/AV ampli-
fier is able to drive up to 5.1 speakers in the main
room.
• Before you change these settings, turn down the vol-
ume.
1
Press the [RECEIVER] button,
followed by the [SETUP] button.
The main menu appears onscreen.
2
Use the Up and Down [
buttons to select "2. Speaker
Setup," and then press [ENTER].
The Speaker Setup menu appears.
ENTER
2. Speaker Setup
1. Speaker Settings
2. Speaker Config
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
6. THX Audio Setup
ENTER
3
Use the Up and Down [
buttons to select "1. Speaker Set-
tings," and then press [ENTER].
The Speaker Settings menu appears.
ENTER
2–1. Speaker Settings
Speaker Impedance
Speakers Type
ENTER
46
4
ENTER
ENTER
5
ENTER
ENTER
6
]/[ ]
Note:
This procedure can also be performed on the AV
receiver/AV amplifier by using its [SETUP] button,
arrow buttons, and [ENTER] button.
]/[ ]
6 ohms
Normal
Use the Up and Down [ ]/[
buttons to select "Speaker
Impedance," and then use the
Left and Right [ ]/[ ] buttons to
select:
4 ohms: Select if the impedance of any
speaker is 4 ohms or more but
less than 6.
6 ohms: Select if the impedances of all
speakers are between 6 and
16 ohms.
Use the Up and Down [ ]/[
buttons to select "Speakers
Type," and then use the Left and
Right [ ]/[ ] buttons to select:
Normal: Select this if you've con-
nected your front speakers
normally.
Bi-Amp:Select this if you've con-
nected your front speakers for
bi-amped operation.
Press the [SETUP] button.
The Setup menu closes.
]
]