Omron NTXS Manual page 59

Default System Tags
1. System Registers
Tags Tag Name
S0001 Language
S0003_14 Comm1 status
S0003_15 Comm2 status
S0004 Number of Historical
S0005 Screen Trigger
S0007 Battery Voltage
S0008 Error code for
Xtradrive Com1
S0009 Error code for
Xtradrive Com2
2. System Bits
Tags Tag Name
s0009 Beeper On /Off
s0010 Battery Status
s0011 Start / Stop jog
s0013 Start / Stop jog
Read / Write
Read / Write Writing the value will change languages
used in any wizard
Read Only 0 = Communication Error
1 = Communicating with PLC
Read Only 0 = Communication Error
1 = Communicating with PLC full status
Read Only Shows number of alarms stored in
memory Alarms
Read / Write Shows active screen no. User can
change Register screen by writing any
valid screen no in this register
Read Only Indicates battery voltage in #.# format
Read only Error code byte for Xtradrive for Com1
Read only Error code byte for Xtradrive for Com2
Read / Write
Read / Write 0: Enable Beeper
1: Disable Beeper
User can change this bit at Run time.
Read only 0: Battery voltage is OK (i.e.above 2.2 V)
1: Low Battery (i.e. below 2.2V)
Read / Write Used in jog operation of Xtradrive for port1
for Xtradrive Com1
1: Continuous jog operation on port1
0: Stop jog operation on port1
Read / Write Used in jog operation of Xtradrive for port2
for Xtradrive Com2
1: Continuous jog operation on port2
0: Stop jog operation on port2
Using NTXS Software
Description
Description
53