Setting Network Configuration For Nt3S Series Products - Omron NTXS Manual

Programmable terminals
Table of Contents

Advertisement

3.3.2

Setting Network Configuration For NT3S Series Products

Unit can communicate with any PLC without any change in hardware. To communicate with PLC unit
needs proper communication driver. Each PLC has a defined protocol for communicating with any
device. PLC driver is downloaded in to unit along with the firmware. This driver enables the unit to talk to
a specific PLC.
Unit can be configured in following ways:
1.
For IBM Communication
2.
For Serial Printing
3.
For PLC Communication
Either of the ports can be configured for the ways mentioned above. Depending on the type of communi-
cation, user may require to define certain parameters.
The following table displays number of nodes connected on Com1 and Com2 with their Node address,
node name, node type (unit / PLC), total number of blocks used in application.
Note: Default Node address for unit is 0 for COM1 and COM2. This address needs to be changed if
settings for PLC address is same as unit address.
Before you Begin
37

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents