Omron NT21 - SETUP MANUAL 10-2001 Setup Manual page 126

Memory Initialization
Reference:
S If the Resume Function memory switch is set to OFF, the memory tables can
be initialized just by switching the NT21 power OFF and back ON again (page
140).
S The bit memory table merely reflects the status of bits at the host and therefore
cannot be initialized.
S If the optional battery is not installed, the memory tables will be initialized when
the PT's power goes OFF even if the Resume Function memory switch is ON.
Initialize the memory tables by following the menu operations from the Mainte-
nance Mode Menu as shown below.
If No is selected, the NT21 returns to the MEMORY INIT. MENU screen without
initializing the memory tables.
On completion of memory table initialization, the message Finished is displayed
and the NT21 returns to the MEMORY INIT. MENU screen.
Select Memory Init..
Select Memory Table.
Select Yes.
The memory tables are initialized. During ini-
tialization, the message Initializing is dis-
played.
Section 6-4
115