Table of Contents
Advertisement
CHAPTER 5 PARAMETERS
Level 1 Mode
Set point lower limit to Set point upper limit
Comment
F Related article
4.3 How to Use Event Input (page 4-8)
F Related parameters
See
"Multi-SP function" "Remote SP enable" (option mode)
"Set point" (level 0 mode) "SP mode" (level 2 mode)
"Input type" "Scaling upper limit" "Scaling lower limit" "Decimal point" (setup
mode)
F Option unit
E53-AKB
Model
Alarm value 1
Alarm value 2
Alarm value 3
• This parameter is used for monitoring or changing the alarm values of alarm outputs
1 to 3.
• During temperature input, the decimal point position is dependent on the cur-
Function
rently selected sensor, and during analog input on the results of scaling.
Comment
F Related article
3.4 Setting Alarm Type (page 3-9)
F Related parameters
See
"Input type" "Scaling upper limit" "Scaling lower limit" Decimal point" "Control
output 1 assignment" "Control output 2 assignment" "Auxiliary output 1 assign-
ment" "Auxiliary output 2 assignment" "Alarm 1 type" "Alarm 2 type" "Alarm 3
type" "Alarm 1 open in alarm" "Alarm 2 open in alarm" "Alarm 3 open in alarm"
(setup mode)
"Alarm 1 hysteresis" "Alarm 2 hysteresis" "Alarm 3 hysteresis" (level 2 mode)
"Standby sequence reset method" (expansion mode)
5--12
Setting Range
Setting Range
Unit
-1999 to 9999
EU
Unit
EU
Conditions of Use
Alarms must be assigned as outputs. For
example, if alarm outputs 1 and 2 only are
assigned as outputs, the "alarm value 3"
parameter cannot be used.
Default
0
Default
0
Advertisement
Table of Contents
