Table of Contents
Advertisement
CHAPTER 5 PARAMETERS
Option Mode
Communication stop bit
Communication data
length
Communication parity
• These parameters set the communications conditions. Make sure that the stop bit,
data length, parity and baud rate of the host computer and the E5EK controller
are matching. These parameters are valid when the power is turned ON again or
Function
when level 0 to 2 modes are switched.
• When connecting two or more E5EK controllers to the host computer, set unit
Nos. that will not conflict with the unit Nos. of other controllers.
• "Communication stop bit" parameter
Comment
• "Communication data length" parameter
• "Communication parity" parameter
[
• "Communication baud rate" parameter
• "Communication unit No." parameter
F Related article
Chapter6 USING THE COMMUNICATIONS FUNCTION
F Related parameter
See
"Remote/Local" (level 2 mode)
F Option unit
E53-AK01/02/03
Model
5--40
Unit
Setting Range
1, 2
Bits
Unit
Setting Range
7, 8
Bits
Setting
]: None/ [
]:Even/[
Setting Range
1.2, 2.4, 4.8, 9.6, 19.2
Unit
Setting Range
0 to 99
None
Conditions of Use
The communications function must be in
use.
Default
2
Default
7
Default
]:Odd
[
Unit
Default
kbps
9.6
Default
0
Communication baud rate
Communication unit No.
]
Advertisement
Table of Contents
