Table of Contents
Advertisement
A manual revision code appears as a suffix to the catalog number on the front cover of the manual.
The following table outlines the changes made to the manual during each revision. Page numbers
refer to previous version.
Revision code
1
2
02A
03
Revision History
Cat. No. H085-E1-03
Date
July 1996
Original production
April 1997
Page V:
Page 1- -6:
Page 2- -8:
Page 2- -10:
Page 3- -3:
Page 3- -8:
Page 5- -8:
Page 5- -9:
Page 5- -13:
Page 5- -14:
Page 5- -15:
Page 5- -16:
Page 5- -17:
Page 5- -23:
Page 5- -28:
Page 5- -33:
Page 5- -42:
Page 5- -43:
Page 6- -3:
Page 7- -4:
Page 7- -7:
Page 7- -9:
Page 7- -10:
Page 7- -12:
Page 7- -13:
Page 8- -4:
Page A- -2:
Page A- -11:
Page A- -14:
Page A- -15:
March 2005
Page A- -3:
June 2010
Page A- -8:
Revision code
Revised content
Changed "100 to 240 VAC" to AC100- -240V
Modified the item of "Model" on the table.
Modified the diagram in "Terminal arrangement".
Changed the power specifications in Power supply".
Deleted some texts in "CT input/Potentionmeter".
Changed some texts in "Remote SP input".
Modified the diagram in "Setup".
Added "run/stop" = "run" to Setting Example.
Added "Model" and "Power specifications" to MV monitor.
Added "Model" and "Power specifications" to Valve opening mon-
itor.
Added "Model" and "Power specifications" to Cooling coefficient.
Added "Model" and "Power specifications" to Dead band.
Added "Model" and "Power specifications" to Position- -propor-
tional dead band.
Added "Model" and "Power specifications" to Manual reset value.
Added "Model" and "Power specifications" to Hysteresis.
Added "Model" and "Power specifications" to Control period.
Added "Model" and "Power specifications" to Heater current
monitor.
Added "Model" and "Power specifications" to Heater burnout.
Added "Model" and "Power specifications" to Open/close hyster-
esis Model.
Added "Model" and "Power specifications" to Control output as-
signment.
Added "Model" and "Power specifications" to PID/ON/OFF.
Added "Model" and "Power specifications" to HBA latch.
Added "Model" and "Power specifications" to Motor Calibration.
Added "Model" and "Power specifications" to Travel Time.
Added "Model" and "Power specifications" to PV dead band.
Modified the diagram in "RS- -232C".
Modified the diagram in "Preparations".
Modified the diagram in "Preparation".
Modified the diagram in "Preparation".
Modified the diagram in "Preparation".
Modified the diagram in "Thermocouple".
Modified the diagram in "Platinum resistance thermometer".
Modified the diagram in "Current input".
Modified the diagram in "Voltage input".
Added "Motor calibration error".
Modified "Ratings specifications".
Changed "Type Name" and "Specification" in Base unit.
Deleted 2) of "At the time the E5EK starts operation" in "Startup
Conditions of SRT".
Deleted 2) of "At the time set point is changed".
Deleted "Imposition Completion Condition of Step Control
Amount".
Modified the diagram in "PID Constant Refreshing Conditions".
Added information to table and accompanying notes.
Changed "%" or "%FS" for hysteresis parameters at bottom of
table.
~
or AC/DC24V
Advertisement
Table of Contents
