Table of Contents
Advertisement
CHAPTER 5 PARAMETERS
Expansion Mode
• The parameters in this mode can be used only when the "security" parameter
(protect mode) is set to "0" and "1".
• This mode contains the parameters for setting expanded functions. These parame-
ters include parameters for setting ST (self-tuning), setting the SP setting limiter,
selecting advanced PID and ON/OFF control, specifying the standby sequence re-
set method, and automatic return of display mode.
• To select this mode when in the levels 0 to 2, setup, option and calibration modes,
press the
play. If you select [
cond minimum, the controller enters the expansion mode.
• To select parameters in this mode, press the
tings, use the
• The following table shows the parameters supported in this mode and the page
where the parameter is described.
5--32
key for 1 second minimum. The display changes to the menu dis-
] using the
or
keys.
Symbol
Set point upper limit
Set point lower limit
PID / ON/OFF
ST
ST stable range
α
AT calculated gain
Standby sequence reset method
Automatic return of display mode
AT hysteresis
LBA detection width
key then press the
key. To change parameter set-
Parameter Name
key for 1 se-
Page
5-33
5-33
5-33
5-34
5-34
5-34
5-35
5-35
5-36
5-36
5-36
Advertisement
Table of Contents
