Omron CP1L CPU Getting Started Manual page 77

4
4-7 Editing Programs
Creating Vertical/Horizontal Lines
4
Note
Copying/Pasting Contacts/Instructions/Rungs
Contacts/Instructions
Rungs
76
SYSMAC CP1L Getting Started Guide
Vertical and horizontal connection lines can be created.
Vertical lines are created as follows:
1.
Position the cursor at the starting point of the vertical line.
2.
Hold down the [Ctrl] key, and press the up/down arrow key.
Horizontal lines can be created in the same manner.
(1) Starting point
(2) Cursor
• Creating a line from right to left:
Hold down the [Ctrl] key and press the left arrow key.
• Creating a line from left to right:
Hold down the [Ctrl] key and press the right arrow key.
• Creating a line from bottom to top:
Hold down the [Ctrl] key and press the up arrow key.
• Creating a line from top to bottom:
Hold down the [Ctrl] key and press the down arrow key.
Repeating the process over an existing connection line will delete it.
1.
Place the cursor on a contact or an instruction.
2.
Hold down the [Ctrl] key and press the [C] key.
The selected contact or instruction will be copied to the clipboard.
3.
Move the cursor to where you wish to paste. Hold down the [Ctrl] key and
press the [V] key.
The contact or instruction on the clipboard will be pasted.
1.
Click the rung header of the rung you wish to copy.
The whole rung will be selected.
2.
Hold down the [Ctrl] key and press the [C] key.
The selected rung will be copied to the clipboard.
3.
Move the cursor to the rung where you wish to paste. Hold down the [Ctrl]
key and press the [V] key.
The rung on the clipboard will be pasted.