Putting The Devices Into Operation; Putting The Sr 300 Iem G3 Transmitter Into Operation - Sennheiser EW 300 IEM G3 Instruction Manual

Putting the devices into operation

Putting the SR 300 IEM G3 transmitter into operation

Setting up the transmitter on a flat surface
Place the transmitter on a flat, horizontal surface. Please note that the device feet can leave
stains on delicate surfaces.
Mounting the rack
To fasten the rack mount "ears"
mount "ears"
Fitting the device feet
Connecting the The supplied rod antenna
rod antenna
When using more than one transmitter, we recommend connecting remote
antennas and, if necessary, using Sennheiser antenna accessories. Fore more
information, visit the ew G3 product page at www.sennheiser.com.
The rack mount "ears" are designed to help protect the operating elements from
damage or deformation, e.g. if the transmitter is dropped. Therefore, fasten the rack
mount "ears", even if you do not want to rack mount your transmitter.
Unscrew and remove the two recessed head screws (M4x8) on each side of the
transmitter.
Secure the rack mount "ears"
removed recessed head screws.
Do not fit the device feet when mounting the transmitter into a 19" rack.
Clean the base of the transmitter where you want to fix the device feet.
Fit the device feet to the four corners of the transmitter.
is suitable for use in good reception conditions.
Connect the rod antenna
Putting the devices into operation
:
to the sides of the transmitter using the previously
to the BNC socket .
9