Sennheiser EW 300 IEM G3 Instruction Manual page 27

Hide thumbs Also See for EW 300 IEM G3:
Table of Contents

Advertisement

Display
Function of the menu item
Warnings
Activates/deactivates the warning messages (color change and warning messages)
LCD Contrast
Adjusts the contrast of the display panel in 16 steps
Reset
Resets the transmitter
When resetting the transmitter, only the selected settings for the pilot tone and for the
frequency banks "U1" to "U6" remain unchanged. For an overview of the factory-preset default
settings, refer to the supplied frequency information sheet.
IP-Address
Adjusts the IP address of the transmitter
Software Revision
Displays the current software revision
Exit
Exits the extended menu
"Warnings"
AF Peak
Audio overmodulation
RF Mute
RF signal is deactivated
Exit
Exits the submenu "Warnings" and returns to the extended menu
Operating menu of the EK 300 IEM G3 diversity receiver
Display
Function of the menu item
Main menu "Menu"
Squelch
Adjusts the squelch threshold, adjustment range: 5 to 25 dBμV, adjustable in 2-dB steps, can be
switched off
CAUTION!
Special function (for servicing purposes only):
With the squelch threshold set to
button pressed for 3 seconds. If you then press the
again.
Easy Setup
Scans for unused frequency presets, releases and selects frequency presets
Frequency Preset
Changes the frequency bank and the channel
Name
Enters a freely selectable name
Balance
Adjusts the balance
Mode
Selects stereo or Focus mode
High Boost
Activates/deactivates the treble boost
Auto Lock
Activates/deactivates the automatic lock mode
Advanced
Calls up the extended menu
Exit
Exits the operating menu and returns to the current standard display
"Advanced
Menu" and returns to the main menu
Danger of hearing damage and material damage!
If you switch the squelch off or adjust the squelch threshold to a very low value, loud
hissing noise can occur in the receiver. The hissing noise can be loud enough to cause
hearing damage or overload the loudspeakers of your system!
Always make sure that the squelch is switched on (see above).
Before adjusting the squelch threshold, set the volume of the headphone output to
the minimum.
Never change the squelch threshold during a live transmission.
"5
dB", you switch the squelch off by keeping the
"Advanced
Menu"
Using the operating menus
"Advanced
UP
rocker button, you switch the squelch on
Menu"
DOWN
rocker
25

Advertisement

Table of Contents
loading

This manual is also suitable for:

300 iem seriesEk 300 iem g3

Table of Contents