Synchronizing Transmitters And Ek 300 Iem G3 Receivers Via The Infra-Red Interface - Sennheiser EW 300 IEM G3 Instruction Manual

Using the devices
20
Synchronizing transmitters and EK 300 IEM G3 receivers via the
infra-red interface
Synchronization allows you to quickly and easily transfer transmitter and receiver settings
from one device to the other, especially if you want to configure a multi-channel system.
There are two transfer directions:
1. Easy Setup Sync: Transfer from the receiver to one or several transmitters
Once you have performed a frequency preset scan with a receiver, you can use the
Easy Setup Sync function to transfer unused frequency presets from the receiver to the
transmitters via the infra-red interface. In order to configure a multi-channel system, you
use the diversity receiver to transfer the first unused channel from the selected frequency
bank to the first transmitter and the next unused channel to the second transmitter and
so on, thus ensuring that all transmitters of a multi-channel system operate on suitable
frequencies.
2. Sync: Transfer from a transmitter to a receiver
Once you have selected and set the desired receiver settings on the transmitter (either
manually or using the Easy Setup Sync
This configures the receiver and establishes a transmission link between transmitter and
receiver.
Via the "Sync Settings" submenu, you can adjust the receiver parameters listed below and
activate or deactivate their transfer to an EK 300 IEM G3 receiver.
Setting Transferred receiver parameter
"Balance" Current balance setting ("−15"/"+15")
"Squelch" Current squelch setting ("Off",
"Mode" Current audio mode setting ("Stereo"/"Focus")
"High Boost" Current treble boost setting
"Auto Lock" Current lock mode setting ("active"/"inactive")
"Limiter" Current limiter setting
When carrying out the
channel setting as well as the receiver parameters adjusted via the
submenu are transferred to the EK 300 IEM G3 receiver via the infra-red interface.
function), you transfer these settings to a receiver.
"5 dB" ...
("flat"/"High
("−18 dB", "−12
Sync function, the transmitter's current frequency bank and
"25 dB")
boost")
dB", "−6 dB", "Off")
"Sync Settings"