Putting The Receiver Into Operation; Inserting The Batteries Or The Accupack; Charging The Accupack; Connecting Headphones - Sennheiser Tourguide 1039 Instruction Manual

Putting the receiver into operation

C h 4
E n g lis h
10 |
Tourguide 1039
Putting the receiver into operation

Inserting the batteries or the accupack

For powering the diversity receiver, you can either use two 1.5 V AA size bat-
teries or the rechargeable Sennheiser BA 2015 accupack.
For daily use, we recommend using the supplied BA 2015 accupack. The
accupack can be charged in the L 2015 charger without having to be
removed from the device.
Open the battery compartment by pushing the two catches
direction of the arrows and open the cover
Insert the BA 2015 accupack or the two batteries as shown above. Please
observe correct polarity when inserting the accupack/batteries.
Close the battery compartment by pressing on the center of the cover
The battery compartment cover

Charging the accupack

To charge the BA 2015 accupack installed in the receiver:
Insert the diversity receiver into the L 2015 charger.
The receiver switches off and the accupack is being charged.
For more information on charging the BA 2015 accupack, refer to the instruc-
tion manual for the L 2015 charger.
Never switch on the receiver during charging because otherwise the
accupack will not be charged correctly.
The L 2015 charger can only charge the BA 2015 accupack. Standard
batteries (primary cells) installed in the receiver or individual
rechargeable battery cells cannot be charged.

Connecting headphones

Connect headphones with an impedance of at least 8  to the 3.5 mm
2
jack socket .
0
.
0
locks into place with an audible click.
A
in the
0
.