Monitoring The Audio Signal Via Headphones - Sennheiser EW 300 IEM G3 Instruction Manual

To completely switch the transmitter off:
Switching the EK 300 IEM G3 diversity receiver on/off
To switch the diversity receiver on:
To switch the diversity receiver off:

Monitoring the audio signal via headphones

CAUTION! Danger of hearing damage!
Listening at high volume levels for long periods can lead to permanent hearing defects.
To monitor the audio signal via the headphone output of the diversity receiver:
To monitor the audio signal via the headphone output of the transmitter:
Stereo Transmitter
When in the operating menu, pressing the
entry (ESC function) and return you to the standard display.
The STANDBY button
mode.
Disconnect the transmitter from the mains by unplugging the mains unit from the wall
socket. The backlighting of the
Turn the volume control
The red ON LED lights up. The "Frequency/Name" standard display appears on the
display panel.
Turn the volume control
The red ON LED goes off and the diversity receiver switches off.
Set the volume control to the minimum position before putting the headphones on.
Do not continuously expose yourself to high volumes.
Connect earphones with a 3.5 mm stereo jack plug to the headphone output
When switching the receiver on, slowly and carefully turn the volume control
Via the receiver's operating menu (see page 24), adjust:
– stereo or Focus operation ("Mode" menu item)
– the balance ("Balance" menu item)
– the treble boost ("High Boost" menu item)
– the limiter ("Limiter" menu item)
The ground connection of the earphones cable serves as the second antenna for
adaptive diversity operation.
Set the headphone volume control
Connect headphones with a ¼" (6.3 mm) stereo jack plug to the headphone output
Gradually increase the volume and monitor the audio signal with the lowest possible
volume.
STANDBY
is backlit in red both during operation and in standby
STANDBY button goes off.
clockwise until it clicks.
counterclockwise until it clicks.
to the minimum position.
Using the devices
button will cancel your
.
clockwise.
17
.