Actions To Be Taken During Board Replacement And After Board Replacement Or After Board Repair; Stored Data Of Ics; Alignment And Setting Required When Replacing If-1278 Board; Alignment And Setting Required When Replacing Sy-449 Board - Sony SUPER MOTION HDC-P43 Service Manual

4-3. Actions to be Taken during Board Replacement and after Board
Replacement or after Board Repair
4-3-1.

Stored Data of ICs

The table below lists data retained in the IC on the following boards.
When any of the following boards or ICs is replaced, deal with action to be taken in replacing parts.
Note
The part number listed in "Spare Parts" is for IC which is not programmed. If replacement is needed, contact your local
Sony Sales Office/Service Center.
Board Ref. No.
(Type)
AT-189V IC401
(eMMC)
DPR-376 IC109
(EEPROM)
IC1303
(Flash)
IF-1278 IC204
(Flash)
SY-449 IC403,
IC404
(FRAM)
IC804
(Flash)
4-3-2.

Alignment and Setting Required when Replacing IF-1278 Board

1. Replace the IF-1278 board.
(Refer to "4-9. IF-1278
2. Compensate the RPN.
(Refer to "5-6. RPN Compensation".)
3. Make electrical adjustment as needed.
(Refer to "5. Electrical Alignment".)
4-3-3.

Alignment and Setting Required when Replacing SY-449 Board

Camera setting status and files are stored in the SY-449 board. When the SY-449 board is replaced, contents of the
reference file, scene file, lens file, and operator file are lost. Store these files in a USB drive and then replace the SY-449
board.
The content of the OHB file stored in the OHB assembly is not lost.
Procedure
1. Store the operator file, scene file, and reference file in a USB drive.
• Operator file (Refer to
• Scene file (Refer to
• Reference file (Refer to
HDC-P43
Stored Data
Software program
Model information data
PLD data
CMOS adjustment data, RPN com-
pensation data
Paint data, etc.
PLD data
Assembly".)
"7-2. Operator File".)
"7-4. Scene File".)
"7-5. Reference File".)
Replacement and Actions
Replacement of the board (not replacing IC)
Necessary (refer to "6-1. Upgrading Software
Replacement of the board
Remove the IC attached to the former board and replace it
to the new board.
Replacement of the board (not replacing IC)
Necessary (refer to "6-2. PLD".)
Replacement of the board (not replacing IC)
Necessary (refer to "4-3-2. Alignment and Setting Required
when Replacing IF-1278 Board".)
Replacement of the board (not replacing IC)
Necessary (refer to "4-3-3. Alignment and Setting Required
when Replacing SY-449 Board".)
Replacement of the board (not replacing IC)
Necessary (refer to "4-3-3. Alignment and Setting Required
when Replacing SY-449 Board".)
Programs".)
4-3