Table of Contents
Advertisement
PQQX13225ZA-BM-5 01.7.17 8:58 AM y [ W 62
Before Requesting Help
Problem
The unit does not work.
"No link to base
Place on cradle and
try again." is displayed
and an alarm tone sounds.
Static, sound cuts in/out,
fades. Interference from
other electrical units.
The handset does not ring.
The line status indications
do not work properly.
The handset display is
blank.
The handset display is still
blank after pressing
(‹)
CH (fi)
EDIT (fl)
,
or
62
Cause and Remedy
≥Check the settings (p. 11–18).
≥Charge the battery fully (p. 14).
≥Clean the charge contacts and charge
again (p. 15).
≥Install the battery properly (p. 61).
≥Place the handset on the base unit and
unplug the AC adaptor to reset. Plug in,
and try again.
≥You are too far from the base unit.
Move closer and try again.
≥Place the handset on the base unit and
try again.
≥Plug in the AC adaptor.
≥Raise the base unit antenna.
≥Locate the handset and the base unit
away from other electrical appliances
(p. 3).
≥Move closer to the base unit.
≥Raise the base unit antenna.
CH (fi)
≥Press
channel in the talk or speakerphone
mode.
≥The ringer volume is set to OFF. Set to
HIGH or LOW (p. 21).
≥Check the settings (p. 11–18).
≥The line mode selection is incorrect.
See page 18.
≥The handset is in the standby mode
(p. 15). Press
(fl)
to turn the display on.
≥Charge the battery fully (p. 14).
(›)
,
.
to select a clearer
(›)
(‹)
CH (fi)
,
,
or
EDIT
Advertisement
Table of Contents
