Table of Contents
Advertisement
62
GETTING TO KNOW YOUR INSTRUMENT PANEL
Lights
By selecting the item "Lights", you can make the
following adjustments:
●
Headlight Sensitivity: Adjust the sensitivity of
headlight brightness.
●
Interior Ambient Lights: Increase or decrease the
brightness of the Interior Ambient Lights.
●
Greeting Lights: Enable/disable the vehicle's
Greeting Lights.
●
Auto High Beam: Activate/deactivate the automatic
main beam headlights — If Equipped.
●
Daytime Running Lights: Activate/deactivate the
daytime running lights.
●
Cornering Lights: Activate/deactivate the cornering
lights — If Equipped.
●
Headlight Off Delay: Set the delay for headlight
shutoff after engine shutoff.
Brakes
By selecting the item "Brakes", you can make the
following adjustments:
●
Hold'n Go: Allows you to select "On" or "Off".
●
Brake Service: Enables a special procedure.
●
Auto Park Brake: Enable/disable auto-insertion of
the Electric Parking Brake.
Doors And Locks
By selecting the item "Doors & Locks", you can make
the following adjustments:
●
Auto Door Lock: Activate/deactivate the automatic
locking of the doors with the vehicle moving.
●
Auto Unlock On Exit: Automatic unlocking of the
doors when exiting the vehicle.
●
Flash Light With Lock: Activate the direction
indicators when closing the doors.
●
Sound Horn With Lock: Activate/deactivate the horn
when pushing the lock button on the Remote
Keyless Entry. The options are "Off," "First Press,"
and "Second Press."
●
Remote Door Unlock Without Passive Entry: Allows
you to choose whether to unlock all the doors or only
the driver's side door on the first push of the unlock
button on the Remote Keyless Entry.
●
Passive Entry — If Equipped: Activate the automatic
locking of the doors.
Charging Schedule
By selecting the item "Charging Schedule", you can
make the following adjustments:
●
Set Schedule: Set the charging schedule for
weekends or weekdays.
●
Activate Schedule: Activate/deactivate the charging
schedule.
●
Set Power Level: Adjust the power level of the
charge.
Start Pairing Process
Engine OFF Procedure
Allows you to turn off the engine from the instrument
cluster in the event of an ignition switch failure.
Instructions for turning off the engine via the
instrument cluster display controls will display in the
instrument cluster.
WARNING LIGHTS AND MESSAGES
The warning/indicator lights will illuminate in the
instrument panel together with a dedicated message
and/or acoustic signal when applicable. These
indications are indicative and precautionary and as
such must not be considered as exhaustive. Always
refer to the information in this chapter in the event of a
failure indication. All active telltales will display first if
applicable. The system check menu may appear
different based upon equipment options and current
vehicle status. Some telltales are optional and may not
appear.
R
W
L
ED
ARNING
IGHTS
Air Bag Warning Light
This warning light will illuminate to indicate
a fault with the air bag, and will turn on
for four to eight seconds as a bulb check
when the ignition is placed in the ON/RUN
position. This light will illuminate with a single chime
when a fault with the air bag has been detected, it will
stay on until the fault is cleared. If the light is either not
on during startup, stays on, or turns on while driving,
have the system inspected at an authorized dealer as
soon as possible.
Brake Warning Light
This warning light monitors various brake
functions, including brake fluid level and
parking brake application. If the brake light
turns on it may indicate that the parking
brake is applied, that the brake fluid level is low, or
that there is a problem with the Anti-Lock Brake
System reservoir.
Advertisement
Table of Contents
