Table of Contents
Advertisement
2.
Push the air release button.
Air Compressor Components
7 — Air Release Button
8 — Quick Connector
9 — Release Button
S
C
R
EALANT
ARTRIDGE
EPLACEMENT
NOTE:
Only use original cartridges, which can be purchased at
an authorized dealer.
Proceed as follows:
1.
Remove the sealant cartridge by pushing the
release button located on the side of the
compressor.
2.
Insert the new sealant cartridge by pushing
downward firmly.
Sealant Cartridge Replacement
1 — Sealant Cartridge
9 — Release Button
JUMP STARTING
If your vehicle has a discharged battery, it can be
jump started using a set of jumper cables and a
battery in another vehicle or by using a portable battery
booster pack. Jump starting can be dangerous if done
improperly, so please follow the procedures in this
section carefully.
NOTE:
When using a portable battery booster pack, follow the
manufacturer's operating instructions and precautions.
The vehicle requires its 12 Volt battery power to turn-
on the vehicle's high voltage battery. The high voltage
battery is used to charge the 12 Volt battery, provide
electric vehicle operation. If the 12 Volt battery has
been discharged, the vehicle can be jump started using
a set of jumper cables and a battery in another vehicle
or by using a portable battery booster pack.
IN CASE OF EMERGENCY
If the vehicle's high voltage battery has also been
discharged, it will need to be recharged to a minimum
operating State Of Charge (SOC) before the vehicle can
be operated:
●
If the vehicle can be connected to a Level 1 or Level
2 charger where it is currently parked, the vehicle
will still require a jump start to allow the vehicle to
begin the battery charging process. Once the vehicle
charging has begun (indicated by the charge status
indicator on top of the vehicle's instrument panel),
the jumper cables can be removed from the vehicle
jump posts.
●
If the vehicle cannot be connected to a Level 1 or
Level 2 charger where it is currently parked, the
vehicle can be moved by connecting 12 Volt power
to the vehicle's jump posts and then shifting the
transmission from PARK (P) into NEUTRAL (N). Power
provided by the jumper cables will also allow the
Electric Park Brake to be released. Carefully move
the vehicle to a Level 1 or Level 2 charge location.
While the vehicle is being moved, the external 12
Volt power must remain connected to the vehicle
jump posts.
NOTE:
Be careful when moving the vehicle - ensure that
control of the vehicle is maintained. Also, ensure that
vehicle is secured to prevent unintentional movement
during and after moving the vehicle. If the external
12 Volt power becomes disconnected from the vehicle
jump posts or there is an interruption of the 12
Volt power while moving the vehicle, the vehicle's
transmission may engage PARK. Do not allow the
jumper cables to come in contact with each other or
to the vehicle, this will result in a short.
173
7
Advertisement
Table of Contents
