Table of Contents
Advertisement
100
STARTING AND OPERATING
7 mph (11 km/h), the system will come back active.
When the vehicle is moving in REVERSE, the system will
remain active as long as the speed remains below the
maximum operating speed of 7 mph (11 km/h). When
the maximum speed limit is exceeded, the system is
disabled and the Park Assist switch LED will illuminate.
The system will become active again if the vehicle
speed reduces below approximately 6 mph (9 km/h).
P
A
S
ARK
SSIST
ENSORS
The three or five Park Assist sensors, located in the rear
fascia/bumper, monitor the area behind the vehicle
that is within the sensors' field of view. The sensors can
detect obstacles from approximately 12 inches (30 cm)
up to 59 inches (150 cm) from the rear fascia/bumper
in the horizontal direction, depending on the location,
type and orientation of the obstacle.
The four Park Assist sensors, located in the front
fascia/bumper (if equipped), monitor the area in front
of the vehicle that is within the sensors' field of view.
The sensors can detect obstacles from approximately
12 inches (30 cm) up to 35 inches (90 cm) from
the front fascia/bumper in the horizontal direction,
depending on the location, type and orientation of the
obstacle.
P
A
W
D
ARK
SSIST
ARNING
ISPLAY
The Park Assist Warning screen will only be displayed
if "Sound and Display" is selected from the Uconnect
ð
system
page
113.
The Park Assist Warning screen is located within the
instrument cluster display. It provides visual warnings to
indicate the distance between the rear fascia/bumper
and/or front fascia/bumper and the detected obstacle
ð
page
57.
P
A
D
ARK
SSIST
ISPLAY
The Park Assist warning screen will be displayed when
the activation conditions described before are met
The system will indicate a detected obstacle by showing
a single arc in the left and/or right front or rear regions
based on the object's distance and location relative to
the vehicle.
If an object is detected in the left and/or right front
or rear region, the display will show a single arc in the
left and/or right front or rear region and the system
will produce a tone. As the vehicle moves closer to
the object, the display will show the single arc moving
closer to the vehicle and the tone will change from a
single 1/2 second tone to slow, to fast, to continuous.
Solid arcs will be shown only when the obstacles are
out of driving tube. In the other case, arcs will be
flashing.
Advertisement
Table of Contents
