Table of Contents
Advertisement
Push The Door Handle Button To Lock
NOTE:
●
After pushing the door handle button, you must
wait two seconds before you can lock or unlock the
doors, using any Passive Entry door handle. This is to
allow you to check if the vehicle is locked by pulling
the door handle without the vehicle unlocking.
●
The Passive Entry system will not operate if the key
fob battery is depleted.
The vehicle doors can also be locked by using the lock
button located on the center dashboard.
Activation/Deactivation Of Keyless Enter 'n Go™
Keyless Enter 'n Go™ can be activated or deactivated
through the instrument cluster display or through the
ð
Uconnect system
page
211.
A
D
L
— I
E
UTOMATIC
OOR
OCKS
F
When the auto door lock feature is enabled, if all of
the doors are closed properly, the door locks will lock
automatically when the vehicle's speed exceeds 12
mph (20 km/h). The auto door lock feature is enabled/
disabled within Uconnect Settings
E
C
MERGENCY
If the electronic key does not work, e.g. if the battery of
the key is low, you can:
●
Unlock the car using the mechanical key inside the
electronic key by acting on the pawl located on the
driver's door. See the "Emergency opening of the
doors from outside" paragraph below.
●
Lock the car by pressing the door open button
placed on the inner door panel for about 5 seconds
keeping the ignition device in OFF position and the
door open. The car will lock all the doors and the
liftgate after about 5 seconds. The LED on the door
button and on the center dashboard will light up to
notify the locking. When the last door is closed the
car will be locked. The car can be locked from any
door, respecting the manoeuvre described above.
NOTE:
After locking the car by emergency manoeuvre, make
sure you do not leave the keys inside the car. The
emergency locking manoeuvre disables the FOBIK-Safe
function.
Opening And Locking Doors In The Event Of Power
Failure
In the event of a flat 12V car battery, the doors can still
be opened or locked because they are equipped with
QUIPPED
an additional power supply.
ð
page
113.
O
LOSING AND
PENING
GETTING TO KNOW YOUR VEHICLE
Opening and Locking Doors in the Event
of Power Failure
If the 12V battery of the car is flat, the doors can still
be opened or locked as they are equipped with an
additional power supply.
Opening the doors
You can open the door in the following ways:
●
with the doors locked, press the door opening button
on the external handle three times within 2 seconds.
●
Turn the pawl placed on the driver's door using the
mechanical key located inside the electronic key.
●
Press the internal door opening button three times in
two seconds.
Locking the doors
The doors can be locked following the emergency
locking manoeuvre. See the "Emergency closing and
opening" paragraph described above.
NOTE:
If the doors are not locked using the emergency locking
procedure, repeat the operation for each single door.
RESET
Resetting the door is automatic for a certain number of
times after which it must be done manually using the
pawl using the key inside the remote control.
31
2
Advertisement
Table of Contents
