Table of Contents
Advertisement
WARNING!
●
Always remove the key fobs from the vehicle
and lock all doors when leaving the vehicle
unattended.
●
For vehicles equipped with Keyless Enter 'n Go™
Ignition, always remember to place the ignition in
the OFF position when exiting the vehicle.
Duplication of key fobs may be performed at
an authorized dealer. This procedure consists of
programming a blank key fob to the vehicle electronics.
A blank key fob is one that has never been
programmed.
NOTE:
●
When having the Sentry Key Immobilizer system
serviced, bring all vehicle keys with you to an
authorized dealer.
●
Emergency keys must be ordered to the correct key
cut to match the vehicle locks.
●
It is not mandatory to replace the key fob if a new
emergency key is needed, and vice versa.
SENTRY KEY
The Sentry Key Immobilizer System prevents
unauthorized vehicle operation by disabling the vehicle.
The system does not need to be armed or activated.
Operation is automatic, regardless of whether the
vehicle is locked or unlocked.
The system uses a key fob, keyless push button
ignition and a Radio Frequency (RF) receiver to prevent
unauthorized vehicle operation. Therefore, only key fobs
that are programmed to the vehicle can be used to
start and operate the vehicle. The system will shut the
engine off in two seconds if an invalid key fob is used to
start the engine.
NOTE:
A key which has not been programmed is also
considered an invalid key, even if it is cut to fit the
ignition switch lock cylinder for that vehicle.
If the Vehicle Security Light turns on during normal
vehicle operation (vehicle running for longer than 10
seconds), it indicates that there is a fault in the
electronics. Should this occur, have the vehicle serviced
as soon as possible by an authorized dealer.
CAUTION!
●
Always remove the Sentry Key from the vehicle
and lock all doors when leaving the vehicle
unattended.
●
The Sentry Key Immobilizer system is not
compatible with some aftermarket remote starting
systems. Use of these systems may result in
vehicle starting problems and loss of security
protection.
All of the keys provided with your new vehicle have been
programmed to the vehicle electronics.
GETTING TO KNOW YOUR VEHICLE
IGNITION SWITCH
K
E
'
G
™ I
EYLESS
NTER
N
O
GNITION
This feature allows the driver to operate the ignition
switch with the push of a button as long as the key fob
is in the passenger compartment.
The START/STOP ignition button has three operating
positions. These positions are OFF, ON, and RUN.
START/STOP Ignition Button
The push button ignition can be placed in the following
positions:
OFF
●
The engine is stopped.
●
No electrical devices are available.
ON
●
The vehicle is not running.
●
Some electrical devices (power locks, alarm, etc.)
are still available.
27
2
Advertisement
Table of Contents
