Table of Contents
Advertisement
36
GETTING TO KNOW YOUR VEHICLE
Rear Head Restraint
1 — Adjustment Button
2 — Release Button
WARNING!
ALL the head restraints MUST be reinstalled in the
vehicle to properly protect the occupants. Follow the
re-installation instructions above prior to operating
the vehicle or occupying a seat.
Head Restraint Removal
To remove a head restraint, raise it as far as it can
go. Then, push the adjustment button and the release
button at the base of each post while pulling the head
restraint up. To reinstall the head restraint, push the
adjustment button and the release button at the base
of each post and put the head restraint posts into the
holes. Then, adjust it to the appropriate height.
NOTE:
Do not reposition the head restraint 180 degrees to
the incorrect position in an attempt to gain additional
clearance to the back of the head.
UCONNECT VOICE RECOGNITION QUICK
TIPS — IF EQUIPPED
I
V
R
NTRODUCING
OICE
ECOGNITION
Start using Uconnect Voice Recognition with these
helpful quick tips. It provides the key Voice Commands
and tips you need to know to control your vehicle's
Voice Recognition (VR) system.
B
V
C
ASIC
OICE
OMMANDS
The following Basic Voice Commands can be given at
any point while using your Uconnect system.
Push the VR button on the steering wheel. After the
beep, say a command. You can also say the system
"Wake Up" word and then say a command:
●
"Cancel" to stop a current voice session.
●
"Help" to hear a list of suggested Voice Commands.
●
"Repeat" to listen to the system prompts again.
Notice the visual cues that inform you of your Voice
Recognition system's status.
G
S
ET
TARTED
The
VR button is used to activate/deactivate your
Voice Recognition system.
Helpful hints for using Voice Recognition:
●
Reduce background noise. Wind noise and
passenger conversations are examples of noise that
may impact recognition.
●
Speak clearly at a normal pace and volume while
facing straight ahead.
●
Each time you give a Voice Command, first push the
VR button, wait until after the beep, then say your
Voice Command.
●
You can interrupt the help message or system
prompts by pushing the VR button and saying a Voice
Command from the current category.
Uconnect Voice Command Buttons
1 — Push To Start Or Answer A Phone Call And Send
Or Receive A Text
2 — Push The Voice Recognition Button To Begin
Radio, Media, Navigation, and Climate Functions
Advertisement
Table of Contents
