Table of Contents
Advertisement
106
STARTING AND OPERATING
CAUTION!
above or below the sensors will not be detected
when they are in close proximity.
●
The vehicle must be driven slowly when using
ParkSense in order to be able to stop in time when
an obstacle is detected. It is recommended that
the driver looks over his/her shoulder when using
ParkSense.
LANESENSE — IF EQUIPPED
L
S
O
ANE
ENSE
PERATION
The LaneSense system utilizes a windshield-mounted
camera to identify lane boundaries and determine the
car's position within those boundaries, ensuring it stays
within the lane.
When one of the lane markings are detected and the
driver drifts out of the lane (no turn signal applied),
the LaneSense system provides a haptic warning in
the form of torque applied to the steering wheel to
prompt the driver to remain within the lane boundaries.
If the driver continues to drift out of the lane, the
LaneSense system provides a visual warning through
the instrument cluster display to prompt the driver to
remain within the lane boundaries.
NOTE:
The torque applied to the steering wheel by the system
is sufficient for the driver to notice it, but always limited,
so that they can easily override it. The driver may
manually override the haptic warning by applying force
to the steering wheel at any time.
If the vehicle continues to drift beyond the lane
boundary without any driver intervention, a warning
light will illuminate on the instrument cluster display,
urging the driver to steer the car back into the lane's
boundaries.
NOTE:
The LaneSense system is operational at speeds above
37 mph (60 km/h) and below 93 mph (150 km/h).
The LaneSense system uses a forward facing camera
to detect lane markings and measure vehicle position
within the lane boundaries.
T
L
S
O
O
URNING
ANE
ENSE
N
R
The LaneSense button is located on the end
of the turn signal stalk, located on the left
side of the steering column.
To turn the LaneSense system on, push the
LaneSense button once. A "Lane Sense On" message is
shown in the instrument cluster display.
To turn the LaneSense system off, push the LaneSense
button twice within 5 seconds.
On some models, when LaneSense is disabled, a
message along with a warning light will be displayed
on the instrument cluster display.
NOTE:
The system will retain the last state (on or off) that
was active during engine shut down. The next time the
engine is started, the system will either be active or
stay off.
C
HANGING
The LaneSense system has settings to adjust the
intensity of the torque warning and the warning zone
sensitivity (early/medium/late) that you can configure
through the Uconnect system screen
NOTE:
Once active, the system will operate when the following
conditions are met:
●
The driver maintains at least one hand on the
steering wheel at all times.
O
●
FF
The vehicle's speed falls within the range of 37 mph
to 93 mph (60 km/h to 150 km/h).
●
The lane is marked on at least one side.
●
Visibility conditions are appropriate.
●
The road is straight or with wide radius bends.
●
The turn signal is not engaged in the same direction
as the lane departure.
NOTE:
The system will not apply torque to the steering wheel
whenever a safety system engages. (Anti-Lock Brakes,
Traction Control System, Electronic Stability Control, Full
Brake Control system, etc.).
L
S
ANE
ENSE
The LaneSense system alerts the driver when the
car drifts out of its lane by displaying symbols and
messages on the instrument panel display.
While the system is in operation and hasn't detected
the lane boundaries, the lane lines appear in grey, and
a specific icon is displayed in the dedicated upper
section of the display.
L
S
S
ANE
ENSE
TATUS
ð
page
113.
W
M
ARNING
ESSAGE
Advertisement
Table of Contents
