Table of Contents
Advertisement
PCP
DEI
CoS ID
Tag Class.
DSCP Based
WRED Group
Ingress Map
Egress Map
Buttons
: Click to apply changes
: Click to undo any changes made locally and revert to previously saved values.
4.4.1.2 Queue Policing
This page allows you to configure the Queue Policer settings for all switch ports.. The Queue Policing screen in
appears.
The classified DPL can be overruled by a QCL entry.
Controls the default
PCP
value.
All frames are classified to a PCP value.
If the port is VLAN aware and the frame is tagged, then the frame is classified to
the PCP value in the tag. Otherwise the frame is classified to the default PCP
value.
Controls the default
DEI
value.
All frames are classified to a DEI value.
If the port is VLAN aware and the frame is tagged, then the frame is classified to
the DEI value in the tag. Otherwise the frame is classified to the default DEI
value.
Controls the default
CoS ID
Every incoming frame is classified to a CoS ID, which later can be used as basis
for rewriting of different parts of the frame.
Shows the classification mode for tagged frames on this port.
Disabled: Use default
CoS
Enabled: Use mapped versions of
Click on the mode in order to configure the mode and/or mapping.
Note: This setting has no effect if the port is VLAN unaware. Tagged frames
received on VLAN unaware ports are always classified to the default CoS and
DPL.
Click to Enable
DSCP
Based QoS Ingress Port Classification.
Controls the
WRED
group membership.
Controls the
Ingress Map
selection through the Map ID. The Ingress Map ID
ranges from 0 to 255. An empty field indicates no map selection.
Controls the
Egress Map
selection through the Map ID. The Egress Map ID
ranges from 0 to 511. An empty field indicates no map selection
249
User's Manual of IGS-6325 series
value.
and
DPL
for tagged frames.
PCP
and
DEI
for tagged frames.
Figure 4-4-1-2
Advertisement
Table of Contents
