Fault Codes - Fisher & Paykel DW24U6I User Manual

If the dishwasher malfunctions, it will display a fault code and beep.
Check the following table below to see if you can correct the fault yourself.
FAULT
CODES AND
DESCRIPTIONS
A20
Drain fault
A10
No water
26

FAULT CODES

POSSIBLE CAUSES
Drain hose is crimped
or bent.
The waste water is
not draining out.
The turbidity
sensor is dirty and
requires cleaning.
Water tap not
turned on.
Insufficient water
supply pressure.
Water inlet hose is
crimped or bent, so no
or not enough water
gets to the dishwasher.
Drain hose is not
connected correctly.
WHAT TO DO
Check the drain hose and straighten
if needed.
Ensure that the drain hose is connected in
accordance with the installation instructions.
Gently clean the turbidity sensor with a soft
brush (ie toothbrush) to remove any buildup.
Turbidity sensor
Ensure the water is connected and turned on.
Touch to restart the dishwasher.
Check household water pressure.
Check the water inlet hose and straighten if
needed. Touch to restart the dishwasher.
Ensure that the drain hose is connected in
accordance with the installation instructions.