After The Wash - Fisher & Paykel DW24U6I User Manual

When the wash programme is over, the dishwasher will beep six times, then
automatically turn off in a few seconds.
Open the door slightly and leave it ajar (about 100mm) to help the drying process.
1
Once the dishes are cool to touch, they can be removed.
2
IMPORTANT!
Never leave the dishwasher door in the fully open position, as this could present
a tripping hazard.
Check that the detergent dispenser is completely empty. If it isn't, wipe out with
3
a damp cloth.
Inspect your dishwasher regularly to see if it needs any cleaning or maintenance:
4
– Check that no grease or limescale deposits have accumulated on the inside.
– If there are food particles in the filters, these need to be cleaned as well.
– See section 'Care and cleaning' for cleaning and maintenance instructions.
Holiday time
If the dishwasher is not going to be used for some time:
Ensure the baskets are empty.
z z
Leave the inside of the dishwasher clean.
z z
Leave the dishwasher door ajar to allow air to circulate.
z z
Turn off both the power and water supply to the dishwasher.
z z
Winterizing (cold climates only)
Disconnect the dishwasher from the power supply,
1
Turn off the water supply and disconnect the water inlet pipe from the water valve.
2
Drain water from the inlet pipe and water valve, using a bucket or pan to collect
3
the water.
Reconnnect the water inlet pipe to the water valve.
4
Remove the drain filter and the filter plate from the bottom of the dishwasher and
5
use a sponge to remove any remaining water in the drain.
Replace the drain filter and the filter plate, and completely dry all water from inside
6
the dishwasher.
Disconnect the drain hose from the sink drain pipe and completely drain all remaining
7
water from the hose. Reconnect the drain hose to the sink drain pipe.
22

AFTER THE WASH