Fault Codes - Fisher & Paykel DISHDRAWER DD24DT2NX9 User Manual

When there is a fault, your DishDrawer™ Dishwasher will beep continuously and a fault code
will flash in the display. There are two types of fault codes: 'F' and 'A'.
There may be a fault in one or both of the drawers. The fault codes may be different in
z
each.
The drawer indicator will flash for one or both of the drawers to show where the fault is.
z
If only one drawer has a fault, you can still use the other drawer.
If you have paused a drawer during a wash program and the other drawer faults, the
z
paused drawer indicator will continue flashing but will be dimmed.
Fixing a fault
You may be able to clear the fault by resetting the DishDrawer™ Dishwasher. Follow the
steps in the following 'F' and 'A' fault code instructions. If the problem persists:
1 Note down the fault code.
Press to scroll between the drawers and note down the code for each drawer.
2 Contact Customer Care for support or to organize a visit by a service technician.
Refer to the Service and Warranty booklet for contact details.
'F' fault codes
1 Press to stop the beeping and again to turn the DishDrawer™ Dishwasher off.
2 Wait a few seconds. Press
If the fault code has disappeared, the fault has been reset and you can continue to use your
DishDrawer™ Dishwasher.
If the fault still exists
Press and note down any additional codes that appear, then disconnect the DishDrawer™
Dishwasher from the power supply, turn off its water supply and contact Customer Care.

FAULT CODES

again to turn the DishDrawer™ Dishwasher back on.
41