Fault Codes - Fisher & Paykel DISHDRAWER DD60DDFB9 User Manual

How do I know if there is a fault?
Your DishDrawer™ Dishwasher will beep continuously and the indicators on the control
panel will light up and flash. There are two types of fault codes – 'F' and 'A'.
If the wash modifier and lock indicators are flashing, it is an 'F' fault.
z
If only the wash modifier indicators are flashing, it is an 'A' fault.
z
With both F and A faults, one or more wash program indicators are also lit.
z
Double models only
There may be a fault in one or both of the drawers and the fault codes may be
z
different in each.
If a fault occurs in one drawer only you are still able to use the other drawer.
z
To fix a fault
First try to fix the issue and clear the code according to the steps in the following tables.
If the problem persists:
1 Note down the fault code.
2 Contact Customer Care for support or to organize a visit by a service technician.
Refer to the Service and Warranty document for contact details.
'F' fault codes
You may be able to clear the fault by resetting the DishDrawer™ Dishwasher, follow the
steps below. When the flashing indicators have disappeared the fault has been reset and
you can continue to use your DishDrawer™ Dishwasher.
DISPLAY
Wash program + lock + one or
more modifiers

FAULT CODES

POSSIBLE CAUSE
Fault on drawer
WHAT TO DO
1 Press to stop the beeping,
then again to turn the
DishDrawer™ Dishwasher off.
2 Wait a few seconds. Press
again to turn the DishDrawer™
Dishwasher back on.
41