Configuring 3800 Series Modems - Paradyne COMSPHERE 6800 Series Communications Products Support Configuration Manual

Other commands related to modem configurations are as follows:
Refer to the COMSPHERE 6800 Series Network Management System Communications Products
Support Command Reference Manual for additional information on these commands.

Configuring 3800 Series Modems

The 3800 Series modems can be configured to perform specific functions by setting the following
options:
These options can be set by executing the following commands:
Change Call Directory (chcd)
Change Options (cho)
Other commands related to modem configurations are, as follows:
Refer to the COMSPHERE 6800 Series Network Management System Communications Products
Support Command Reference Manual for additional information on these commands.
6800-A2-GB20-20
Display Call Directory (dscd)
Display Options (dso)
Display Port Options (dspo)
Display Port Speed(s) (dspsp)
Display Telephone Number(s) (dstn)
COMSPHERE 3600 Series DSUs can interoperate with
DATAPHONE II 2600 Series DSUs when the 3600 Series DSUs are
optioned to be 2600 DSU compatible. To be compatible, the device
profiles of the 3600 Series DSUs must be defined as 2600 Series
models. This will cause the 6800 Series NMS to treat this device as
a DATAPHONE II device. At the device level, this device will be
treated as a tributary DSU. The device has no additional
capabilities. The user should add a comment in the device profile to
note that the device is actually a 3600 Series DSU in 2600
emulation mode.
call directory
device options
fault-monitoring parameters
Execute this command to change the telephone number(s) in a call directory.
Execute this command to set the options of a 3800 Series modem. This command is used
to set the circuit, diagnostic, and Data Terminal Equipment (DTE) interface features.
Display Call Directory (dscd)
Display Options (dso)
January 1997
NOTE
Configuring Devices
2-5