Table of Contents
Advertisement
7.5
Local commissioning
7.5.1
Wizard overview
Note
Important information regarding the use of commissioning wizard
• Settings for quick start wizard are inter-related and changes apply only after "Finish" is set
to "Yes" in final step.
• Do not use quick start wizard to modify individual parameters.
Perform customization for your application only after "Quick start" wizard has been
completed.
Note
Parameter settings properly stored
In order to ensure parameter settings are properly stored in the device, wait 30 seconds after
any configuration change before removing power from the device.
1. Press
2. Configure each parameter per step, then select "Next" to proceed. In the final step, when
asked to "Finish", choose "Yes" to save changes.
3. Next, "Exit" the wizard. After exiting the wizard, press
view.
The wizard illustrations in this section show an overview of each commissioning wizard and
of the buttons used to navigate through the wizard.
In the upper left corner of each view, the wizard name appears, followed by each step name.
In the upper right corner, the view number is shown. The number of steps depends on the
actual device variant ordered.
①
②
③
SITRANS TDL
Compact Operating Instructions, 05\2023, A5E51659183-AA – revised 03/2024
to enter the "Quick start" menu, and again to start the "Quick start" wizard.
Step name/Parameter name, e.g. "Medium pressure"
Wizard name, e.g. "Quick start"
View number/Total views in wizard, e.g. 4th view of 13
Commissioning
7.5 Local commissioning
button to return to operation
43
Advertisement
Table of Contents
