Requirements For Special Applications - Siemens SITRANS TDL Compact Operating Instructions

In situ laser gas analyzers

Hide thumbs Also See for SITRANS TDL:

Table of Contents

Safety notes

3.2 Requirements for special applications

3.2

Requirements for special applications

Due to the large number of possible applications, each detail of the described device versions

for each possible scenario during commissioning, operation, maintenance or operation in

systems cannot be considered in the instructions. If you need additional information not

covered by these instructions, contact your local Siemens office or company representative.

Note

Operation under special ambient conditions

We highly recommend that you contact your Siemens representative or our application

department before you operate the device under special ambient conditions as can be

encountered in nuclear power plants or when the device is used for research and

development purposes.

Pressure safety

For pressure specifications, refer to the Technical specifications (Page 52).

Damage to operating staff

Whenever the optics housings heads are to be opened or disconnected from the process

interface or the gas tubing, make sure that any overpressure in the optics housings heads is

removed prior to any work. Opening optics housings under overpressure may result in

dangerous injuries to the operator.

Damaged optics

The high pressure-proof glass in the optics housings must not be subject to any mechanical

impact which might cause damage to the glass (scratch, gash etc.). Only use a soft cloth for

cleaning of the glass. Make sure that it is safe to dismount the optics housing before

cleaning.

Malfunction of sealing

Make sure all plugs and tube fittings are sealed with the enclosed pipe thread sealant.

Instructions given on the sealant tube must be carefully followed.

WARNING

Compact Operating Instructions, 05\2023, A5E51659183-AA – revised 03/2024

SITRANS TDL

Table of Contents