Table of Contents
Advertisement
14.5 Starting the programme
Note: If the intelligent dosing system
is activated, make sure that the dis-
pensers have been filled → Page 35
and the basic dosage has been set
→ Page 36.
Requirement: A programme is set.
→ "Setting a programme", Page 32
Press Start Reload.
1.
The drum rotates and load detec-
a
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
The display shows the programme
a
duration or the programme end
time.
After the programme has ended,
a
the display shows: End.
If the display shows
2.
is not spun. The water is pumped
out after the rinse cycle.
Notes
If you do not remove the laundry
¡
once the programme has ended,
the crease-reduction function starts
after 15 minutes and takes approx.
30 minutes. The display shows 0：
00， ， and End alternately,
and
appears.
Press any button on the display to
cancel the crease-reduction pro-
gramme and to remove the laun-
dry.
If "Hot" appears, the appliance
¡
cools the laundry.
When "Hot" goes out, the laundry
has cooled down.
14.6 Soaking laundry
Note: No additional detergent is re-
quired for soaking. The appliance
uses the filled detergent for soaking
and washing.
, the laundry
Requirements
The laundry is placed in the appli-
¡
ance.
→ "Loading laundry", Page 32
A programme has started.
¡
→ "Starting the programme",
Page 33
Press Start Reload approx.
1.
10 minutes after the programme
start.
The programme pauses and the
laundry can soak.
Press Start Reload after the re-
2.
quired soaking time.
14.7 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Press Start Reload.
1.
During the washing cycle, the ap-
pliance pauses.
During the drying cycle, the appli-
ance checks whether it is possible
to add laundry.
Note: If you want to add laundry,
follow the instructions on the dis-
play.
→ "Display", Page 23
Open the door.
2.
Add or remove laundry.
3.
Close the door.
4.
Press Start Reload.
5.
14.8 Cancelling the washing
programme
Press Start Reload.
1.
Open the door.
2.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Rinse programme.
Basic operation en
33
Advertisement
Table of Contents
