Table of Contents
Advertisement
en Troubleshooting
Fault
"E:30 / -10" and/or
lights up.
flashes.
"Hot" and the drum ro-
tates.
"H:95" lights up altern-
ately with End.
44
Cause and troubleshooting
First wait approx. 5 minutes until the drain process
1.
ends.
To reset the error message, switch the appliance
2.
off.
Switch the appliance back on.
3.
If the error message is displayed again, call cus-
4.
tomer service.
→ "Customer Service", Page 55
The detergent drawer has not been pushed in fully.
Push in the detergent drawer until the symbol goes
▶
out.
The pump unit is not inserted.
Insert the pump unit into the detergent drawer.
1.
→ "Cleaning the detergent drawer", Page 37
Push in the detergent drawer until the symbol goes
2.
out.
The temperature is too high.
Wait until the temperature has dropped.
▶
Cancel the programme.
▶
→ "Cancelling the washing programme", Page 33
Water level is too high.
Select a suitable programme for draining.
▶
→ "Programmes", Page 27
Door is not closed.
Close the door.
▶
Laundry is caught in the door.
Remove any trapped laundry.
▶
Cooling process active.
Not a fault.
1.
Do not change the programme during the cooling
2.
process.
Note: The cooling process takes up to 10 minutes.
You can continue to operate the appliance.
Drum cleaning is required.
→ "Cleaning the drum", Page 37
▶
The water pressure is low.
See
▶
→ "E:30 / -10 and/or
", Page 44
Advertisement
Table of Contents
