Table of Contents
Advertisement
en Troubleshooting
Fault
The programme dura-
tion changes during
the wash cycle.
Drum jerks after the
programme starts.
Fluff on the laundry.
The laundry is too
damp.
52
Cause and troubleshooting
Note: When loading, where possible, place large and
small items of laundry together in the drum. Different
sized items of laundry distribute themselves better
during the spin cycle.
Foam detection system switches on a rinse cycle if
foam build-up is too high.
Not a fault – no action required.
▶
This is caused by an internal motor test.
Not a fault – no action required.
▶
Fluff has accumulated in the drum.
Run the Cottons 90° programme without any laun-
▶
dry or detergent.
Unsuitable programme for the type of fabric.
There has been a power cut.
Check whether the lighting in your room or other
▶
appliances are working.
The load is too large.
After the end of the programme, warm laundry feels
damper than it actually is.
Remove the laundry from the drum as soon as the
1.
drying programme has finished.
Spread the items of laundry for cooling.
2.
Drying target not adjusted.
Load too small.
Water tap is closed during the drying phase.
Make sure that the water tap also remains open
▶
during the drying phase.
The ambient temperature is greater than 30 °C.
Ensure that the ambient temperature is below 30
▶
°C.
Insufficient air circulation at the appliance's installation
location.
Ventilate the appliance's installation location.
▶
The water pressure is low.
No remedial action possible.
Laundry is not spun sufficiently.
Always select the highest possible spin speed for
▶
the washing programme in question.
Thick and multi-layered fabrics require a longer drying
time.
Advertisement
Table of Contents
