Table of Contents
Advertisement
Fault
High spin speed not
reached.
The spin programme
does not start.
Water is leaking out at
the water inlet hose.
Water is leaking out at
the water outlet hose.
Insufficient cleaning.
Cause and troubleshooting
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
Start the Spin programme.
▶
Drain pipe or water outlet hose is blocked.
Clean the drain pipe and the water outlet hose.
▶
Drain pipe or water drain hose is caught or jammed.
Ensure that the drain pipe and water drain hose are
▶
not kinked or trapped.
The unbalanced load detection system has interrupted
the spin cycle because the laundry is unevenly distrib-
uted.
Redistribute the laundry in the drum.
▶
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
Start the Spin programme.
▶
Water inlet hose is not correctly/securely connected.
Connect the water supply hose correctly.
1.
→ "Connecting the water inlet hose", Page 15
Tighten the screw connection.
2.
The water outlet hose is damaged.
Replace the damaged water outlet hose.
▶
Water outlet hose is not connected correctly.
Connect the water outlet hose correctly.
▶
→ "Water outlet connection types", Page 16
Basic dosage not adjusted.
If intelligent dosing is activated, adjust the basic
▶
dosage. → Page 36
Detergent or care products have congealed in dis-
pensers of the intelligent dosing system.
Check whether the detergent used is suitable.
1.
→ "Detergents and care products", Page 32
Drain the dispenser.
2.
→ "Cleaning the detergent drawer", Page 37
Clean the dispenser.
3.
Refill the dispenser.
4.
→ "Pouring liquid detergent and fabric softener into
the dispensers", Page 35
Troubleshooting en
49
Advertisement
Table of Contents
