Using The Manual Dosing Compartment; Setting The Basic Dosage Amount; Basic Settings; Overview Of The Basic Settings - Siemens WN54G1A1GB User Manual And Installation Instructions

Table of Contents

Advertisement

en Basic settings
16.2 Using the manual dosing
compartment
If you are not using the intelligent
dosing system, if intelligent dosing is
not possible for a programme, or if
you want to add additional care
product, e.g. stain remover or starch,
use the manual dosing compartment.
Note: Observe the information about
detergents and care products
→ Page 32.
Pull out the detergent drawer.
1.
Pour laundry detergent or care
2.
product into the manual dosing
compartment → Page 18.
Push in the detergent drawer.
3.
16.3 Setting the basic dosage
amount
To allow for intelligent dosing, set the
basic dosage amount for the dis-
penser. The basic dosage amount
corresponds to the dosage recom-
mendation from the detergent manu-
facturer on the packaging. Set the
basic dosage amount that corres-
ponds to the dosage recommenda-
tion for 4.5 kg of normally soiled
laundry. In doing so, note the water
hardness.
Press and hold ⁠   i-Dos for approx.
1.
3 seconds.
The display shows the basic
a
dosage set for
To set the basic dosage for
2.
press ⁠   i-Dos.
To adjust the setting, press Ready
3.
in/ Time Dry.
Press briefly to save the setting.
4.
36
.
,

Basic settings

17 Basic settings
You can configure the basic settings
Basic settings
for your appliance to meet your
needs.
17.1 Overview of the basic
settings
Programme selector with programme
positions
Set the volume of the signal
2
at the end of the programme:
0 (off) to 4 (very loud)
Set the volume of the signal
3
tone emitted when the but-
tons are pressed:
0 (off) to 4 (very loud)
Activate (On) or deactivate
4
(OFF) the reminder to clean
the drum.
Display the number of fin-
5
ished programmes.
17.2 Changing the basic set-
tings
Set the programme selector to po-
1.
sition 1. → Page 36
1
2
3
4
5

Advertisement

Table of Contents
loading

Table of Contents