Table of Contents
Advertisement
Fault
"E:30 / -80"
"H:32"
"E:30 / -10" and/or
Cause and troubleshooting
Ensure that the drain pipe and water drain hose are
▶
not kinked or trapped.
The water outlet hose is connected too high.
Install the water outlet hose at a maximum height of
▶
1 metre.
Unapproved extension installed on the water drain
hose.
Remove any unapproved extensions from the water
▶
hose.
→ "Connecting the appliance", Page 15
Detergent dosage is too high.
Immediate measure: Mix one tablespoon of fabric
▶
softener with 0.5 litres of water and pour the mix-
ture into the compartment for manual dosing (not
for outdoor clothing, sportswear or items stuffed
with down).
If intelligent dosing is activated, reduce the basic
▶
dosage. → Page 36
If you dose manually, reduce the amount of deter-
▶
gent for the next washing cycle with the same load.
The unbalanced load detection system has interrupted
the spin cycle because the laundry is unevenly distrib-
uted.
Redistribute the laundry in the drum.
▶
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
The water pressure is low.
No remedial action possible.
The filters in the water inflow are blocked.
Clean the filters in the water inflow.
▶
The tap is turned off.
Turn on the tap.
▶
The water inlet hose is kinked or jammed.
Ensure that the water inlet hose is not kinked or
▶
jammed.
Water level measurement system is defective.
Note: With the error message, the appliance starts a
draining process.
Troubleshooting en
43
Advertisement
Table of Contents
