Gree GPH10ARC-A6NNA1A Owner's Manual page 10

2. Attach the insect guard to the back of the win-
dow panel (panel A). Push it in to make sure it
fits properly. If you do not want to install the rain
guard, proceed to Step 4.
Insect guard
3. Optional : Install the rain guard on the insect
guard to prevent rainwater from entering the ex-
haust pipe.
a) Slide the projections of each rain guard into the
notches of the insect guard. Side "A" should
be on top as indicated in the illustration below.
Notches
b) Firmly insert the insect guard to ensure that
the four projections fit into the notches in the
main window panel (panel A). Make sure the
"A" side is on top.
Projections
A
Window panel
10
INSTALLATION GUIDE
Panel A
FIGURE 4
Notches
A
Projections
FIGURE 5
Projections
Window panel
FIGURE 6
4. Slide the exhaust cover into the grooves of the
main window panel (panel A).
Exhaust
cover
5. Installing the Window Panel(s) :
This window kit consists of 3 panels that can be
adjusted to the exact size of your window. You
may not need to use all three panels. To get
started, please refer to the guide below :
● If your window is less than 71 cm (28 inches)
A long you only need the window panel A. You
may need to saw off part of the panel if your
window is smaller than the window panel
length.
● If your window is 71 to 117 cm (28 to 46 inches)
long, you will need panel A and panel B. You
will not need the extension panel C.
● If your window is 117 to 157 cm (46 to 62 inches)
long, you will need all three panels.
● Finally, if your window is longer than 157 cm
(62 inches), you will need all three panels and
then have to improvise to fill the remaining
space.
See next page for specific dimensions of each
A
panel.
Insert on the
grooves
FIGURE 7