Yamaha VP-1 Owner's Manual page 56

LFO DELAY
Adjusts the voice's (element's) LFO delay — the gap between the time you strike the
key and the time the LFO effect begins. Raise the slider to increase the delay.
LFO HOLD
Adjusts the voice's (element's) LFO hold time — the length of time that the LFO
effect lasts. Raise the slider to increase the hold time.
EG ATTACK
Adjusts the attack rate of the voice's (element's) envelope generator. Raise the slider
to slow down the sound change.
Envelope generator
Attack rate Decay rate
Level
Sustain level
Note on
EG DECAY
Adjusts the decay rate of the voice's (element's) envelope generator. Raise the slider
to slow down the sound change.
EG SUSTN
Adjusts the sustain level of the voice's (element's) envelope generator. Raise the
slider to increase the level.
EG RELSE
Adjusts the release rate of the voice's (element's) envelope generator. Raise the slider
to slow down the sound change.
Important
• If Portamento Mode (
connected a foot switch to the Portamento jack, the VP1 will produce portamento
only while the switch is depressed.
• Some voices do not use EG or LFO functions. For these voices, changes to the EG
or LFO parameters are meaningless.
REFERENCE: 1-30) is not set to "fingered" and you have
Quick Editing
Release rate
Time
Note off
BASICS
Chapter 3 Learning the Basics
3 - 19