Remove A Diffserv Class - NETGEAR S3600 Series User Manual

S3600 Series 8- or 16-Port 10G/Multi-Gigabit Ethernet Smart Switch with 2 SFP+ Ports
If you did not yet activate your warranty, the Register to activate your warranty page
displays. For more information, see Register the switch on page 35.
3. Enter one of the following passwords:
• Enter your device admin password.
• If you previously managed the switch through the Insight Cloud Portal or Insight
app, enter the Insight network password for the last Insight network location.
For information about the credentials, see Credentials for the device UI on page 34.
4. Click the Login button.
The Dashboard page displays.
5. Select QoS > DiffServ > Class Configuration.
The Class Configuration page displays.
6. Click the class name, which is a hyperlink.
The page on which you can change the class configuration displays.
7. In the DiffServ Class Configuration section, change the class configuration as needed.
For more information about the settings, see Add and configure a DiffServ class on
page 361.
8. Click the Apply button.
Your settings are saved.

Remove a DiffServ class

You can remove a DiffServ class that you no longer need.
To remove a DiffServ class:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network,
or connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser and enter the IP address of the switch in the address field of
your web browser.
If you do not know the IP address of the switch, see Access the switch on-network
and connected to the Internet on page 25 or Access the switch off-network and not
connected to the Internet on page 32.
The Device Admin Password page displays.
If you did not yet activate your warranty, the Register to activate your warranty page
displays. For more information, see Register the switch on page 35.
3. Enter one of the following passwords:
Configure Quality of Service 365 User Manual